Draytek P2260 Manual Do Utilizador
VigorSwitch P2260 User’s Guide
40
Media type
NWay
Speed
Duplex
100M TP
ON/OFF 10/100M
Full/Half
1000M TP
ON/OFF 10/100/1000M Full for all, Half for
10/100
1000M Fiber ON/OFF 1000M
Full
In Auto-negotiation mode, no default value. In Forced mode,
default value depends on your setting.
default value depends on your setting.
Flow Control:
There are two modes to choose in flow control, including
Symmetric and Asymmetric. If flow control is set
Symmetric, both parties can send PAUSE frame to the
transmitting device(s) if the receiving port is too busy to
handle. When it is set Asymmetric, this will let the receiving
port care the PAUSE frame from transmitting device(s), but
it doesn’t send PAUSE frame. This is one-way flow control.
Default: Symmetric.
Symmetric and Asymmetric. If flow control is set
Symmetric, both parties can send PAUSE frame to the
transmitting device(s) if the receiving port is too busy to
handle. When it is set Asymmetric, this will let the receiving
port care the PAUSE frame from transmitting device(s), but
it doesn’t send PAUSE frame. This is one-way flow control.
Default: Symmetric.
2
2
.
.
2
2
.
.
3
3
S
S
i
i
m
m
p
p
l
l
e
e
C
C
o
o
u
u
n
n
t
t
e
e
r
r
The function of Simple Counter collects any information and provides the counting about
the traffic of the port, no matter the packet is good or bad.
the traffic of the port, no matter the packet is good or bad.
In the following figure, the window can show all ports’ counter information at the same
time. Each data field has 20-digit long. If the counting is overflow, the counter will be reset
and restart counting. The data is updated every time interval defined by the user. The valid
range is 3 to 10 seconds. The Refresh Interval is used to set the update frequency. Default
update time is 3 seconds.
time. Each data field has 20-digit long. If the counting is overflow, the counter will be reset
and restart counting. The data is updated every time interval defined by the user. The valid
range is 3 to 10 seconds. The Refresh Interval is used to set the update frequency. Default
update time is 3 seconds.
Function name:
Simple Counter
Function description:
Display the summary counting of each port’s traffic, including Tx Byte, Rx Byte, Tx
Packet, Rx Packet, Tx Collision and Rx Error Packet.
Packet, Rx Packet, Tx Collision and Rx Error Packet.