SMSC LAN9311 Manual Do Utilizador
Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
Revision 1.4 (08-19-08)
44
SMSC LAN9311/LAN9311i
DATASHEET
speed_strap_2
Port 2 Speed Select Strap: Configures the default value
for the
for the
bit in
When configured low, 10 Mbps is selected. When
configured high, 100 Mbps is selected.
configured high, 100 Mbps is selected.
This strap also affects the default value of the following bits:
PHY_SPEED_SEL_LSB bit of the
10BASE-T Full Duplex (bit 6) and 10BASE-T Half Duplex
(bit 5) bits of the
(bit 5) bits of the
MODE[2:0] bits of the
Refer to the respective register definition sections for
additional information.
additional information.
1b
duplex_strap_2
Port 2 Duplex Select Strap: Configures the default value
for the
for the
bit in the
PHY_BASIC_CTRL_2 register (See
).
When configured low, half-duplex is selected. When
configured high, full-duplex is selected.
configured high, full-duplex is selected.
This strap also affects the default value of the following bits:
PHY_DUPLEX bit of the
10BASE-T Full Duplex (bit 6) of the
MODE[2:0] bits of the
Refer to the respective register definition sections for
additional information.
additional information.
1b
BP_EN_strap_2
Port 2 Backpressure Enable Strap: Configures the
default value for the
default value for the
bit of the
. When configured low, backpressure is
disabled. When configured high, backpressure is enabled.
1b
FD_FC_strap_2
Port 2 Full-Duplex Flow Control Enable Strap:
Configures the default value of the
Configures the default value of the
bits in the
,
which are used when manual full-duplex control is selected.
When configured low, full-duplex Pause packet detection
and generation are disabled. When configured high, full-
duplex Pause packet detection and generation are enabled.
When configured low, full-duplex Pause packet detection
and generation are disabled. When configured high, full-
duplex Pause packet detection and generation are enabled.
1b
Table 4.2 Soft-Strap Configuration Strap Definitions (continued)
STRAP NAME
DESCRIPTION
PIN / DEFAULT
VALUE
VALUE