Siemens 6ED1050-1AA00-0BE8 Manual Do Utilizador
Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
Manual, 04/2011, A5E03556174-01
Manual, 04/2011, A5E03556174-01
89
Note
You can invert individual inputs of the basic and special functions; that is, if an input
You can invert individual inputs of the basic and special functions; that is, if an input
carries a logical "1" signal, the circuit program will output a logical "0". On the other hand,
a logical "0" is inverted into a logical "1" signal.
To invert an input, move the cursor to the relevant position, e.g.:
[
,4
,ุ
,%
Confirm with OK.
Now press or to invert this input:
Next, press ESC.
Now press or to invert this input:
Next, press ESC.
[
,4
,ุ
,%
4
%
,
,
,
,
,
ุ
[
<RXUFLUFXLWSURJUDPOD\RXW
You can review your first circuit program by pressing or to move the cursor through the
circuit program.
We shall now exit circuit programming mode. To return to the programming menu: Press
We shall now exit circuit programming mode. To return to the programming menu: Press
ESC
Note
LOGO! has now saved your circuit program to nonvolatile memory. The circuit program
LOGO! has now saved your circuit program to nonvolatile memory. The circuit program
remains in the LOGO! memory until you explicitly delete it.
You can save the actual values of special functions in the case of a power outage assuming
You can save the actual values of special functions in the case of a power outage assuming
that these functions support the "Retentive" parameter and that the necessary program
memory is available. The Retentive parameter is deactivated when you insert a function; to
use it, you must enable this option.