Extron electronic SCP 250 Manual Do Utilizador

This full-size template is a guide for cutting a hole for the
2-gang size electrical box for the SCP 200 or for the SCP 200
itself (if it will be installed directly into furniture or wall).

The light gray area represents the layout of the 

electrical box (3.75"H x 3.75"W) against the rear 

of the SCP 200 front panel.

The dashed line indicates the cut-out 

area (3.95"H x 3.95"W) for installing

the electrical wall box.

To install the control panel 

without  a wall box,

use the cut-out area (3.00"H x 3.70"W)

indicated by the dotted line.

Use the templates as a guide to mark and cut the hole in the wall
or furniture through which the SCP control pad will be installed.
The templates include the recommended 0.1” (0.25 cm)
clearance on all sides of the electrical wall box to allow room for
the raised areas surrounding the knockouts.  See the installation
chapter for details on installing the control pads.

The SCP/AAP A will usually be mounted in an AAP faceplate/
bracket or an architectural series interface, distribution
amplifier, or other device.  The full-size template below can be
used if you are going to install the SCP/AAP A directly into
furniture.

The light gray area

represents the 

SCP/AAP A's

 circuit boards.

To install the SCP/AAP A 

without  a wall box 

or an AAP bracket, use the cut-out area

 (2.7"W x 2.05"H) (6.9 cm W x 5.2 cm H)

indicated by the dotted line.