Extreme networks 12802 Manual Do Utilizador
Extreme Networks 325 W DC Power Supply
BlackDiamond 12800 Series Switches Hardware Installation Guide
35
NOTE
The Extreme Networks 325 W DC PSU cannot be used in combination with any other Extreme Networks PSU.
The Extreme Networks 325 W DC PSU requires input DC cable Model 65025 (see
). The input
DC cable has an input connector on one end and precut wire on the other end that goes to the DC
power source. The connector end has a locking mechanism that locks onto the DC PSU to prevent
accidental removal of the input DC cable.
power source. The connector end has a locking mechanism that locks onto the DC PSU to prevent
accidental removal of the input DC cable.
This cable is shipped separately from the power supply unit. You must use this cable with the Extreme
Networks 325 W DC PSU.
Networks 325 W DC PSU.
Figure 18: Input DC Cable for the Extreme Networks 325 W DC PSU
Each Extreme Networks 325 W DC PSU must be powered by a 15 A dedicated power source that
delivers -40 to -72 VDC constant power to each 325 W DC PSU. Power distribution to the 325 W DC
PSU shall be provided using the Model # 65025 -48 V DC cable. Power to the 325 W DC PSU can be
from either a 15 A UL-approved overcurrent protection breaker or an SELV-approved power source in
accordance with IEC 60950-1 utilizing 15 A overcurrent protection.
delivers -40 to -72 VDC constant power to each 325 W DC PSU. Power distribution to the 325 W DC
PSU shall be provided using the Model # 65025 -48 V DC cable. Power to the 325 W DC PSU can be
from either a 15 A UL-approved overcurrent protection breaker or an SELV-approved power source in
accordance with IEC 60950-1 utilizing 15 A overcurrent protection.
Minimum Software Required
You must be running ExtremeWare XOS version 12.0 or later for the system to recognize the DC PSU.
LEDs
The front panel of the Extreme Networks 325 W DC PSU provides status LEDs.
describes the
meanings of these LEDs.
Table 12: LEDs on the 325 W DC PSU
PSU Condition
DC In
LED Status
LED Status
DC Out
LED Status
LED Status
No DC input power
Off
Off
No DC input power (receiving standby power from the chassis)
Amber
Off
DC input good (main outputs disabled)
Green
Off
DC input good, output fault
Green
Amber
DC input good, DC output good
Green
Green
DC_PSU_05
Brown
Green/
yellow
yellow
Blue
10 ft.
3
6
1
4
(RTN)
(–48V)
(Ground)