Fortinet 548B Manual Do Utilizador

 

 

- 257 - 

 

This command begins the re-authentication sequence on the specified port. This command is only valid if 
the control mode for the specified port is 'auto'. If the control mode is not 'auto' an error will be returned. 

 

dot1x re-authenticate <slot/port> 

 

<slot/port> - is the desired interface number. 

 

None 

Privileged Exec 

 

 

This command sets the value, in seconds, of the timer used by the authenticator state machine on this 
port. Depending on the token used and the value (in seconds) passed; various timeout configurable 
parameters are set. The following tokens are supported. 

guest-vlan-period: The time, in seconds, for which the authenticator waits to see if any EAPOL packets 
are received on a port before authorizing the port and placing the port in the guest vlan (if configured). The 
guest vlan timer is only relevant when guest vlan has been configured on that specific port. 

reauth-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this 
port to determine when re-authentication of the supplicant takes place. The reauth-period must be a value 
in the range 1 - 65535. 

quiet-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this 
port to define periods of time in which it will not attempt to acquire a supplicant. The quiet-period must be 
a value in the range 0 - 65535. 

tx-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to 
determine when to send an EAPOL EAP Request/Identity frame to the supplicant. The quiet-period must 
be a value in the range 1 - 65535. 

supp-timeout: Sets the value, in seconds, of the timer used by the authenticator state machine on this 
port to timeout the supplicant. The supp-timeout must be a value in the range 1 - 65535.