Fortinet 548B Manual Do Utilizador

 

 

- 840 - 

Refresh - Refresh the page with the latest Tunnel entries.   

 

 

 

Loopback interfaces can be created, configured and removed on this page.   

 

 

 

Loopback - Select list of currently configured loopback interfaces. Create is also a valid choice if the 
maximum number of loopback interfaces has not been created.   

Loopback ID - When 'Create' is chosen from the Loopback selector this list of available loopback ID's 
becomes visible.   

Protocol - Select IPv4 or IPv6 to configure the corresponding attributes on the loopback interface.   

IPv6 Mode - Enable IPv6 on this interface using the IPv6 address. This option is only configurable 
prior to specifying an explicit IPv6 address.   

IPv6 Address - Select list of configured IPv6 addresses for the selected Loopback interface. Add is 
also a valid choice if the maximum number of addresses has not been configured.   

IPv6 Address - When 'Add' is chosen from the IPv6 Address selector this IPv6 address input field 
becomes visible. Address must be entered in the format prefix/length. 
The user also has the option to specify the 64-bit extended unique identifier (EUI-64).   

IPv4 Address - The primary IPv4 address for this interface in dotted decimal notation.   

IPv4 Subnet Mask - The primary IPv4 subnet mask for this interface in dotted decimal notation.   

Secondary Address - Select list of configured IPv4 secondary addresses for the selected Loopback 
interface. Add Secondary is also a valid choice if the maximum number of secondary addresses has 
not been configured. A primary address must be configured before secondary addresses can be 
added.  

Secondary IP Address - The secondary ip address for this interface in dotted decimal notation. This 
input field is visible only when 'Add Secondary' is selected.   

Secondary Subnet Mask - The secondary subnet mask for this interface in dotted decimal notation. 
This input field is visible only when 'Add Secondary' is selected.