GarrettCom MNS-6K 4.1.4 Manual Do Utilizador
M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Syntax configure port-security – sets the port authorization based on MAC addresses
Syntax port-security – configure port security settings
Syntax allow mac=<address|list|range> port=<num|list|range> - specify a specific
Syntax port-security – configure port security settings
Syntax allow mac=<address|list|range> port=<num|list|range> - specify a specific
MAC address or MAC address list
Syntax learn port=<number-list> <enable|disable> - learn MAC addresses connected to the
Magnum 6K switch
Syntax show port-security – display port security settings
Syntax action port=<num|list|range> <none|disable|drop> - action to perform in case of
Syntax action port=<num|list|range> <none|disable|drop> - action to perform in case of
breach of port security
Syntax signal port=<num|list|range> <none|log|trap|logandtrap> - port to monitor
and signal to send in case of breach of port security
Syntax ps <enable|disable> - enable or disable port security
Syntax remove mac=<all|address|list|range> port=<num|list|range> - remove a
Syntax remove mac=<all|address|list|range> port=<num|list|range> - remove a
MAC address entry
Syntax show log [fatal|alert|crit|error|warn|note|info|debug] – display the log
Syntax clear log [fatal|alert|crit|error|warn|note|info|debug]– clear the log
Syntax set logsize size=<1-1000> - set the number of line to be collected in the log before the oldest
Syntax set logsize size=<1-1000> - set the number of line to be collected in the log before the oldest
record is re-written
Syntax syslog – syslog context commands
Syntax server add host=<host|ip> [port=<port>] [event=<all|none|default|list>]
– add a syslog server. Maximum of five servers can be defined
Syntax server edit id=<id> [host=<host|ip>] [port=<port>]
[event=<all|none|default|list>] - edit the server setup as well as which syslog messages
the server should receive
the server should receive
Syntax server del id=<id> - delete a Syslog server
Syntax server <enable|disable> id=<id
>
- enable or disable the log messages being sent to a
syslog server
Syntax syslog <enable|enable> - enable (or disable) the syslog messages
Syntax show syslog – display the syslog settings
Syntax access – setup access configuration parameters
Syntax allow ip=<ipaddress> mask=<netmask> service=<name|list> - allow specific
Syntax allow ip=<ipaddress> mask=<netmask> service=<name|list> - allow specific
IP address or range of addresses as a trusted host(s)
104