GarrettCom MNS-6K 4.1.4 Manual Do Utilizador
M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
speed – specifically sets the speed to be 10 or 100Mbps. Note – this works only with
10/100 ports – with 10Mbps ports, the option is ignored. No error is shown. See speed
settings section below.
flow – sets up flow control on the port. See Flow Control section below
bp – back pressure – enables back pressure signaling for traffic congestion management
status – disable – disables the port from operation
Syntax show port[=<port number>]
In the example listed below, the ports 11 and 12 are given specific names. Ports 9 and 13
are active, as shown by the link status. Port 13 is set to 100 Mbps – all other ports are set
to 10Mbps. All ports are set with auto sensing (speed)
10/100 ports – with 10Mbps ports, the option is ignored. No error is shown. See speed
settings section below.
flow – sets up flow control on the port. See Flow Control section below
bp – back pressure – enables back pressure signaling for traffic congestion management
status – disable – disables the port from operation
Syntax show port[=<port number>]
In the example listed below, the ports 11 and 12 are given specific names. Ports 9 and 13
are active, as shown by the link status. Port 13 is set to 100 Mbps – all other ports are set
to 10Mbps. All ports are set with auto sensing (speed)
Magnum6K25#
device
Magnum6K25(device)##
setport port=11 name=JohnDoe
Magnum6K25(device)##
setport port=12 name=JaneDoe
Magnum6K25(device)##
show port
Keys:
E = Enable
D = Disable
H = Half Duplex
F = Full Duplex
M = Multiple VLANs
NA = Not Applicable
LI = Listening
LE = Learning
F = Forwarding
B = Blocking
Port Name Status Dplx Media Link
Speed Part Auto Vlan GVRP STP
-------------------------------------------------------------------------------------------------------------
9 B1
9 B1
E H 10Tx UP 10
No
E 1
-
-
10 B2
E
H 10Tx DOWN 10 No
E 1
-
-
11 JohnDoe E H 10Tx DOWN 10 No
E 1
-
-
12 JaneDoe E H 10Tx DOWN 10
No
E 1
-
-
13 B5
E F
100Tx UP 100 No
E 1
-
-
14 B6
E H 10Tx DOWN 10
No
E 1
-
-
15 B7
E H 10Tx DOWN 10
No
E 1
-
-
16 B8
E H 10Tx DOWN 10 No
E 1
-
-
Magnum6K25(device)##
exit
Magnum6K25#
F
IGURE
75 – Port setup
The port’s speed and duplex (data transfer operation) setting are summarized below.
Speed settings
Auto (default) – Senses speed and negotiates with the port at the other end of the link
for data transfer operation (half-duplex or full-duplex). “Auto” uses the IEEE 802.3u
auto negotiation standard for 100Base-T networks. If the other device does not comply
for data transfer operation (half-duplex or full-duplex). “Auto” uses the IEEE 802.3u
auto negotiation standard for 100Base-T networks. If the other device does not comply
124