Avaya 580 Manual Do Utilizador
Document No. 10-300077, Issue 2
12-3
Configuring IP Routing
Requirements for IP Routing
Hardware Requirements
To configure your switch as an IP router, you must configure your switch
with the following hardware:
with the following hardware:
■
Layer 3 supervisor module
* Note: Licensed layer 3 80-series media modules are recommended for
best routing performance.
Software Requirements
To configure your switch as an IP router, with 80-series modules
(Supervisor and Media modules) you must configure your switch with a
minimum of version 5.0 and above.
(Supervisor and Media modules) you must configure your switch with a
minimum of version 5.0 and above.
Minimum Configuration Requirements
Your switch must be configured as follows to successfully create IP routing:
■
VLANs (subnets) have been created to address current or future
network configurations, or if you plan to expand your current
network.
network configurations, or if you plan to expand your current
network.
■
Assign an IP address, and subnet mask to each configured IP
interface.
interface.
■
IP unicast forwarding must be globally enabled.
■
At least one routing protocol (RIPv1,RIP v2, OSPFv2) must be
enabled, if communication between routers is necessary.
enabled, if communication between routers is necessary.