Avaya ELAT Manual Do Utilizador

ExpertNet Lite Assessment Tool - User Guide

Install the Avaya Traffic Simulator on each remote endpoint you want to test. Each 
remote endpoint MUST be on the same Voice VLAN on which the VoIP equipment will 
be eventually installed. Each Traffic Simulator will take approximately 2 minutes to 
install.

See Appendix A: Installing the Controller and Test Agents for information on installing 
the test agents.

When you restart the PC after installing the Traffic Simulator, the application icon will 
display in your taskbar. The icon displays in red if the tool is not running and in green 
if it is. Configure the test agent using the following process:

1.   Double-click the icon in the task bar.
2.   Ensure the IP address in the ExpertNet Controller field is the IP address of the 

PC with the controller installed.

3.   In the Local Command Port field, enter the port number that will be used to 

receive commands. This value should match the Command Port value in step 7 

of the ELAT Configuration Wizard and should not be changed unless required by 

the network or firewall configuration.

4.   Adjust the log level as appropriate for your needs. Setting this value to max may 

have an adverse effect on the accuracy of results. Setting it to max would only be 

required whenever there is a problem that requires debugging by support 

engineers for ELAT.

5.   Click OK.

When the test agents are configured thay should autmatically register with the 

Controller. An RTP test will be automatically created for each end-point. These will 

display in the network Paths View. This will be explained in detail in the next 

section.