Avaya C460 Manual Do Utilizador

Chapter 2        Avaya C460 CLI Commands

Avaya C460 Reference Guide

91

To configure the outband interface on VLAN 1, IP address 149.49.75.174 and 
netmask 255.255.255.24

User level: read-write, admin.
Use the set interface ppp command to configure the C460 Supervisor Module  
PPP interface IP parameters, exit modem mode, disconnect the PPP session, or reset 
the connected modem.
You must configure an IP address and net-mask for the C460 before you can 
establish a PPP connection. The IP address is a dummy address that is shared 
between two peers, and must be taken from a subnet that is different from the 
agent’s IP sub-net. 

The syntax for this command is:

<ip_addr> <net-mask>

Example:

User level: read-write, admin.
You can also use the set interface ppp command to enter modem mode, enter 
terminal mode, disconnect the PPP session or to reset the connected modem.
The syntax for this command is:

C460-1# set interface outband 149.49.75.174 24

Interface outband IP address set.

You must reset the device in order for the change to take 

effect.

ip_addr

IP address used by the C460 Supervisor Module to connect via 
its PPP interface

net-mask

Subnet mask used by the C460 Supervisor Module to connect 
via its PPP interface

C460-1# set interface ppp 149.49.34.125 24 

Interface ppp ip address set