Avaya C460 Manual Do Utilizador

Chapter 2        Avaya C460 CLI Commands

Avaya C460 Reference Guide

99

User level: read-write, admin.
Use the set port auto-negotiation-flowcontrol-advertisement 
command to set the flowcontrol advertisement for a Gigabit port when performing 
autonegotiation.

The syntax for this command is:

 <module>/

<port> [mode]

Example:

User level: read-write, admin.
Enables or disables a Link Aggregation Group (LAG) interface on the switch. LAG 
creation requires a LAG name to be specified. There is no default name. 
You can also add or remove a port from an existing LAG. All ports in the LAG are 
configured with the parameters of the first port that is added to the LAG. These 
parameters include port administrative status, speed, duplex, autonegotiation 
mode, VLAN ID, tagging mode, binding mode, and priority level. When adding a 
port to an existing LAG, the user must type the same LAG-name (or no LAG-name), 

module

Number of the module (3-6). 

port

Number of the port on the module. If you do not specify a 
number, all the ports on the module are set.
You can also specify a range of ports separated by a dash, 
for example, 4/5-13 for ports 5 to 13 on module 4.

mode

• no-flowcontrol – the port will advertise no pause 

capabilities.

• asym-tx-only – the port will advertise asymmetric Tx 

pause capabilities only.

• sym-only – the port will advertise symmetric pause 

capabilities only.

• sym-and-asym-rx  –  the  port will advertise both 

symmetric and asymmetric Rx pause capabilities.

C460-1# set port auto-negotiation-flowcontrol-advertisement 

 asym-tx-only

Port 2/5 pause capabilities was set