Avaya C460 Manual Do Utilizador
Avaya C460 Reference Guide
13
Chapter 2
Avaya C460 CLI Commands
This chapter describes all the C460 CLI commands and parameters in alphabetical
order.
order.
access list
area
User level: read-write, admin.
L You can only access this command in Router-OSPF mode.
L You can only access this command in Router-OSPF mode.
Type router ospf at the command prompt to enter Router -OSPF mode if
necessary.
necessary.
Use the area command to configure the area ID of the router.
Use the no area command to delete the area ID of the router (set it to 0) and
remove the stub definition.
The default area is 0.0.0.0.
L You cannot define a stub area when OSPF is redistributing other protocols or
Use the no area command to delete the area ID of the router (set it to 0) and
remove the stub definition.
The default area is 0.0.0.0.
L You cannot define a stub area when OSPF is redistributing other protocols or
when the Area ID is 0.0.0.0.
The syntax for this command is:
[no] area
<area id> [<stub>]
Example:
area id
IP address
stub
Stub
Router-1 (configure router:ospf) # area 192.168.49.1
Router-1 (configure router:ospf) # area 192.168.49.1 stub