Avaya C460 Manual Do Utilizador
Chapter 2 Avaya C460 CLI Commands
42
Avaya C460 Reference Guide
Example:
ip access-list-dscp trust
User level: read-write, admin.
Use the ip access-list-dscp trust command to decide which original
frame fields influence the selection of packet priority.
Use the ip access-list-dscp trust command to decide which original
frame fields influence the selection of packet priority.
The syntax for this command is:
ip access-list-dscp trust <policy-list-number>
{untrusted|trust-cos |trust-dscp}
Example:
ip access-list-name
User level: read-write, admin.
L If you are at the “read-write” user level, you can only access this command in
L If you are at the “read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip access-list-name command to set a name for a policy list.
The syntax for this command is:
ip access-list-name
<policy-list-number> <name>
C460-1(configure)# ip access-list-dscp precedence
C460-1(configure)#
policy-list-
number
number
A valid id number for a policy list currently defined for the module
(100 to 149)
(100 to 149)
untrusted
Forward the packet with priority 0
trust-cos
Forward the packet with its original 802.1p priority (default)
trust-dscp
Forward the packet with the maximum priority between 802.1p and
the priority obtained from the DSCP-CoS mapping table
the priority obtained from the DSCP-CoS mapping table
C460-1(configure)# ip access-list-dscp trust 100 trust-dscp
Done!
<policy-list-number>
integer (100 to 149)