Avaya C460 Manual Do Utilizador

Chapter 2        Avaya C460 CLI Commands

70

Avaya C460 Reference Guide

{switch | all} 

Example:

L The nvram initialize command does not alter the Active/Standby status of the 

Supervisor modules.

User level: read-write, admin.
L You can only access this command in Router-OSPF mode. 

Type router ospf at the command prompt to enter Router -OSPF mode if 
necessary.

Use the passive interface command to allow interfaces to be flooded into the 
OSPF domain as OSPF routes and not external routes.
Use the no passive interface command to disble the flooding.
L An interface becomes passive only if you use the network command to enable 

OSPF to run on the interface.

The syntax for this command is:

passive-interface <interface-name/net addr>

Example:

switch

Resets all the switch information (Layer 2 only).

all

Resets all parameters including routing parameters in the 
switch.

C460-1# nvram initialize

This command will restore factory defaults, and can 

disconnect your telnet session

*** Reset *** - do you want to continue (Y/N)? y

Connection closed by foreign host

interface-name / 
net addr

Name of interface or IP address.

Router-1# passive-interface FastEthernet 1.10