Avaya P332MF Manual Do Utilizador

Chapter 6

CLI – Layer 2

94

Avaya P332MF User’s Guide

ROUTE HOST TABLE

destination      gateway          flags  Refcnt  Use           Interface

------------------------------------------------------------------------

127.0.0.1        127.0.0.1        5      2       131           lo0

10.10.10.10      192.168.1.1      7      0       0             se0

------------------------------------------------------------------------

Use the 

set snmp community

 command to set or modify the switch’s SNMP 

community strings.

The syntax for this command is:

set snmp community <access_type> [community string]

Output Example:

P330-1(super)# set snmp community read-only read

SNMP read-only community string set

Use the

 set snmp trap 

commands to add an entry into the SNMP trap receiver 

table and to enable or disable the different SNMP traps for a specific receiver. First 
add the 

rcvr_addr 

and then enable/disable the different traps for it.

The syntax for this command is:

set snmp trap <rcvr_addr>

set snmp trap <rcvr_addr> {enable|disable} {all|config|fault|...}

access type

read-only, read-write, or trap

enable

Activate SNMP traps

disable

Deactivate SNMP traps

all

(Optional) Specify all trap types

config

(Optional) Specify the ConfigChange trap from the TRAP-MIB.

fault

(Optional) Specify the Fault trap from the TRAP-MIB.

rcvr_addr

IP address or IP alias of the system to receive SNMP traps