Avaya M770 Manual Do Utilizador

Chapter 9

Managing Static Routing

Avaya M770 ATM Switch User’s Guide

119

All ATM addresses that are entered in the routing table must begin with the 

AFI that is supported by the switch. The current AFIs supported by a M770 ATM 
Switch are 39, 47, and 45. For more information about these AFIs, see Viewing or 
changing the switch prefix in Chapter 4, “Managing Miscellaneous Commands”.

Once routes have been added, you can view them using the 

route show

 

command. For more information about displaying the routes in a routing table, see 
“Listing the routing entries in a routing table” on page 120.

When you delete a routing entry that is currently being used for an established 
connection, this connection will not be affected. The deletion will take effect next 
time you set up the connection.
To delete a route from the routing table, use the

route delete

command. 

It is not recommended that you delete routes that were added dynamically by 

ILMI.

Internal routes that have been added to the routing table by an entity that is 

internal to the switch (for example, by LANE services) cannot be deleted.

Command:

M15-155s8:/>route delete <address> <vport id> [<vport id>...]

Examples:

M15-155s8:/>route delete 

39.00.00.00.00.00.00.00.01.f6.e0.00.21.11.31.6f.00.28.01

8.1.0

Parameters:

<address>

This can be either the 19-byte hexadecimal address or a 
partial.

<vport id>

A virtual port that was used to route to the specified ATM 
address.