Avaya P130 Manual Do Utilizador

Chapter 6        Avaya P130 CLI

100

 Avaya P130 User’s Guide

Use the 

set interface ppp command to configure the IP parameters of the 

device’s PPP interface. No PPP connection can be established with the device until it 
is configured with a non-null IP address and net-mask. This IP address is a dummy 
address shared only between the two peers. It must be taken from an IP sub-net 
different than the IP sub-net of the agent.

The syntax for this command is:
set interface ppp <ip-address> <net-mask>

Example:
P130-1# set interface ppp 149.49.34.125 255.255.255.0
Interface PPP has its IP address set.

Use the 

set interface ppp  command to disconnect the PPP session, or to reset 

the connected modem. Use the provided on demand DB-25 to RJ45 connector for 
plugging-in the RJ-45 to RJ-45 delivered cable into the modem’s DB-25 connector 
from one side, while the other cable’s side RJ-45 connector should be plugged into 
the device’s Console RJ-45 port of any box..

The syntax for this command is:&_
set interface ppp {enable | enable-always | disable | off | 
reset}

 

Example:
P130-1# set interface ppp off 
PPP session disconnected.

P130-1# set interface ppp reset
PPP has reset the connected modem.

enable

Enable the use of PPP, and thus to enter the modem mode.

enable-always

Entering the Modem mode every time that the proprietary 
modem cable is plugged into the console port.

disable

Disable the use of PPP, and thus to enter the terminal mode.

off 

Keyword to disconnect the active PPP session.

reset

Keyword to reset the connected modem.