Avaya P130 Manual Do Utilizador
Chapter 4 Installation and Setup
28
Avaya P130 User’s Guide
5
Set the baud rate, ppp authentication, and ppp time out required to match your
modem. These commands are described in the “Command Line Interface”
chapter.
modem. These commands are described in the “Command Line Interface”
chapter.
6
At the prompt, type:
set interface ppp enable
set interface ppp enable
The CLI responds with the following:
Entering the Modem mode within 60 seconds...
Please check that the proprietary modem cable is plugged
into the console port
into the console port
7
Use the DB-25 to RJ-45 connector to plug the console cable to the modem’s DB-
25 connector. Plug the other end of the cable RJ-45 connector to the
Avaya P130 console’s RJ-45 port.
25 connector. Plug the other end of the cable RJ-45 connector to the
Avaya P130 console’s RJ-45 port.
8
The Avaya P130 enters modem mode.
9
You can now dial into the switch from a remote station, and open a Telnet
session to the PPP interface IP address.
session to the PPP interface IP address.
Assigning P130’s IP Stack Address
Note:
All P130 switches are shipped with the same default IP address. You must
change the IP address of the master P130 switch in a stack in order to guarantee that
the stack has its own unique IP address in the network.
the stack has its own unique IP address in the network.
Use the CLI to assign the P130 stack/standalone switch an IP address and net mask.
The network management station can establish communications with the stack/
standalone switch once this address had been assigned and the stack/standalone
switch has been inserted into the network.
To assign a P130 IP stack/standalone switch address:
1
The network management station can establish communications with the stack/
standalone switch once this address had been assigned and the stack/standalone
switch has been inserted into the network.
To assign a P130 IP stack/standalone switch address:
1
Establish a serial connection by connecting a terminal to the Master P130 switch
of the stack.
of the stack.
2
When prompted for a Login Name, enter the default name root
3
When you are prompted for a password, enter the password root. You are
now in Supervisor Level.
now in Supervisor Level.
4
At the prompt, type:
set interface inband
set interface inband
<vlan> <ip_address> <netmask>
Replace <vlan>, <ip_address> and <netmask> with the VLAN,
IP address and net mask of the stack.
IP address and net mask of the stack.
5
Press Enter to save the IP address and net mask.
6
At the prompt, type reset and press Enter to reset the stack. After the Reset,
log in again as described above.
log in again as described above.
7
At the prompt, type set ip route <dest> <gateway> and replace <dest>
and <gateway> with the destination and gateway IP addresses.
and <gateway> with the destination and gateway IP addresses.
Press Enter to save the destination and gateway IP addresses.