Avaya 2520-24-POE Manual Do Utilizador

 

TMA; Reviewed: 
SPOC 11/16/2009 

Solution & Interoperability Test Lab Application Notes 

©2009 Avaya Inc. All Rights Reserved. 

5 of 10 

ProC2520-24PoE 

 

 

  No ProCurve 2520-24-PoE Switch specific configuration is required on Avaya Aura

TM

 

Communication Manager or Avaya IP Office to support this solution. 

  For additional configuration details, refer to Section [9]. 

The configuration covered here is specific to PoE and does not include configuration of other 
features available in the ProCurve 2520-24-PoE Switch. Consult the ProCurve 2520-24-PoE 
Switch configuration manual [9] for additional configuration details. 

 

Inline PoE is supported on the ProCurve 2520-24-PoE Switch.  By default, PoE support is 
enabled on the system and on all ports. 

The general test approach was to:  
 

  Connect the Avaya IP Telephones to ports on the ProCurve 2520-24-PoE Switch and 

verify that the PDs successfully booted. 

 

  Power cycle the ProCurve 2520-24-PoE Switch and verify successful boot operation of 

the PDs and registration of the telephones.  

All Power over Ethernet test cases completed successfully.  The ProCurve 2520-24-PoE Switch 
successfully provided inline power to all of the Avaya IP Telephones listed in Table2. Table 2 
lists the measured power of the Avaya IP Telephones when connected to the ProCurve 2520-24-
PoE Switch. The power listed as measured by the ProCurve 2520-24-PoE Switch is for PDs 
under idle conditions.  
 
Note: Cable length and impedance affect power usage, so the measurements listed here may vary 
based on the cable used.