Avaya P330-ML-ML Manual Do Utilizador

Chapter 1        Using the CLI

4

Avaya P330-ML Reference Guide

Universal Commands

Universal commands are commands that can be issued anywhere in the hierarchical 
tree. 

The Up command moves you up to the next highest level in the CLI command 
hierarchy. The Top command moves you to the highest level.

Use the retstatus command to show whether the last CLI command you 
performed was successful. It displays the return status of the previous command.
The syntax for this command is: retstatus
Output Example:

P330 # set port negotiation 2/4 disable

Link negotiation protocol disabled on port 2/4.

The tree command displays the commands that are available at your current 
location in the CLI hierarchy.
The syntax for this command is: tree

P330 Sessions

You can use  sessions to switch between the CLI of P330 modules / other stack 
entities (for example, an X330 ATM or WAN entity plugged into a specific P330 
switch or with the G700 Media Gateway Precessor) or to switch between Layer 2 
and Layer 3 commands in the router module.
To switch between P330 modules use the command: 
session [<mod_num>] <mode>

. 

The <mod_num> is the number of the module in the stack, counting from the bottom 
up.
The <mode> can be either switch, router, wan, atm, mgp. 
Use switch mode to configure layer 2 commands. 
Use router mode to configure routing commands. 
Examples:
To configure router parameters in the module that you are currently logged into, 
type the following command:

.