Brocade Communications Systems 53-1001762-01 Manual Do Utilizador
Converged Enhanced Ethernet Command Reference
189
53-1001762-01
DRAFT: BROCADE CONFIDENTIAL
Chapter
12
QoS Commands
cee
Applies a CEE Provisioning map on an interface.
Synopsis
cee name
no cee
Operands
name
Specifies the name of a previously created CEE map. Any existing CEE map
must be removed before a new one can be applied.
must be removed before a new one can be applied.
Defaults
There is no CEE Provisioning applied on an interface.
Command
Modes
Interface configuration mode
Description
Use this command to apply a CEE map on an interface. Use the no cee command to remove the
CEE Provisioning map.
CEE Provisioning map.
Usage
Guidelines
The CEE map applied on an interface should exist on the switch.
Examples
To apply a CEE map on an interface:
switch(conf-if-te-0/1)#cee demo
Because the switch does not allow applying a CEE map that does not exist, the following error
displays:
displays:
switch(conf-if-te-0/1)#cee test
% Error: Map does not exist
See Also
cee-map