McDATA 4314 Manual Do Utilizador

To configure the switch using the command line interface, do the following:

1. Open a Telnet session with the default switch IP address and log in to the 

switch with default account name and password (admin/password).

telnet 10.0.0.1

Switch Login: admin

Password:     *******

2. Open an admin session and enter the Set Setup System command. Enter 

the values you want for switch IP address (Eth0NetworkAddress) and the 
network mask (Eth0NetworkMask). Refer to the McDATA 4314 Command 
Line Interface Guide for more information about this command.

DFCSM #> admin start

DFCSM (admin) #> set setup system

3. Open a Config Edit session and use the Set Config command to modify 

the switch configuration. Refer to the McDATA 4314 Command Line 
Interface Guide for more information about these commands.

Connect cables to the SFP transceivers and their corresponding devices, and 
then energize the devices. Device host bus adapters can have SFP (or SFF) 
transceivers or GigaBit Interface Converters (GBIC). LC-type duplex fiber 
optic cable connectors are designed for SFP transceivers, while SC-type 
connectors are designed for GBICs. Duplex cable connectors are keyed to 
ensure proper orientation. Choose the fiber optic cable with the connector 
combination that matches the device host bus adapter.

GL_Ports self configure as FL_Ports when connected to loop of public devices 
or F_Ports when connected to a single device. G_Ports self configure as 
F_Ports when connected to single public devices. Both GL_Ports and G_Ports 
self configure as E_Ports when connected to another switch.