McDATA 3232 Manual Do Utilizador
2
Task 25: Configure the Switch from the SANpilot Interface (Optional)
2-109
Installation Tasks
Configure Switch
Ports
Ports
Perform procedures in this section to configure names and operating
characteristics for Fibre Channel ports. To configure one or more
switch ports:
characteristics for Fibre Channel ports. To configure one or more
switch ports:
1. At the View panel, select the Configure option at the left side of the
panel. The Configure panel opens with the Ports page displayed
(
(
Figure 2-89
Configure Panel (Ports Page)
a. For each port to be configured, type a port name of 24
alphanumeric characters or less in the associated Name field.
The port name should characterize the device to which the
port is attached.
The port name should characterize the device to which the
port is attached.
b. Click a check box in the Blocked column to block or unblock a
port (default is unblocked). A check mark in the box indicates
a port is blocked. Blocking a port prevents the attached device
or fabric switch from communicating. A blocked port
continuously transmits the offline sequence (OLS).
a port is blocked. Blocking a port prevents the attached device
or fabric switch from communicating. A blocked port
continuously transmits the offline sequence (OLS).
c. Click the check box in the FAN column to enable or disable the
fabric address notification (FAN) feature (default is enabled).
A check mark in the box indicates FAN is enabled. When the
feature is enabled, the port transmits FAN frames after loop
A check mark in the box indicates FAN is enabled. When the
feature is enabled, the port transmits FAN frames after loop