McDATA 8832 Manual Do Utilizador
IBM BladeCenter Deployment Guide
Figure 16 Changing boot order from Management Module for HS20
3.2 Configuring the Qlogic HBA
3.2.1 Acquiring HBA WWPNs (World Wide Port Names)
Each HBA has a unique WWPN by which it is identified in a SAN network. Accurate tracking of
WWPNs ensures that each server has the proper storage presented to the appropriate location. The
recording of the WWPN information is only required once for ESM to perform zoning for the SAN. If
this has already been performed, skip to Section 3.2.2.
WWPNs ensures that each server has the proper storage presented to the appropriate location. The
recording of the WWPN information is only required once for ESM to perform zoning for the SAN. If
this has already been performed, skip to Section 3.2.2.
To acquire these WWPNs:
• Restart the target blade server being configured for remote boot and enter the QLogic BIOS utility
• Restart the target blade server being configured for remote boot and enter the QLogic BIOS utility
using CTRL+Q. This must be done at a specific time during the POST. Note: you must click the
“sticky” Ctrl icon on the Remote Control page when using the Management Module for this task,
and then you’ll only need to press “Q” on the keyboard.
“sticky” Ctrl icon on the Remote Control page when using the Management Module for this task,
and then you’ll only need to press “Q” on the keyboard.
• One at a time, select each HBA listed and record the WWPNs
18
http://w3-03.ibm.com/support/techdocs/atsmastr.nsf/WebIndex/WP100564
The BladeCenter Deployment Guide is intended as a personal productivity tool. It is not intended to be comprehensive and is provided for
guidance only, on an 'as is basis' without warranty of any kind. Please be aware that its contents have not been certified by IBM.
© 2006 IBM Version 3.0, 3/10/2006