McDATA 4500 Manual Do Utilizador
5
Reset Configuration
5-9
Using Maintenance Features
using this option, record the switch’s current IP address which
displays below the switch’s icon in the EFC Manager’s Product View
(view Display Options set to Network Address). You can also find the
current IP address through the SANpilot Interface.
displays below the switch’s icon in the EFC Manager’s Product View
(view Display Options set to Network Address). You can also find the
current IP address through the SANpilot Interface.
After resetting the configuration, you must reset the original address
on the switch through the maintenance port or the SANpilot Interface
to maintain LAN connections and communication with the service
processor.
on the switch through the maintenance port or the SANpilot Interface
to maintain LAN connections and communication with the service
processor.
Procedure
1. Set the switch offline. For instructions, refer to
2. Select Reset Configuration from the Maintenance menu on the
menu bar. The following warning displays:
WARNING
This operation will reset all switch configuration data and
non-volatile settings to factory default values. All optional
features will also be disabled. The switch must be offline to
continue.
non-volatile settings to factory default values. All optional
features will also be disabled. The switch must be offline to
continue.
If you have enabled features that add additional port function since the
switch was shipped from the factory, these features will be disabled (factory
default) when the configuration is reset. Only those ports that were enabled
at the factory will function. You will have to enable the additional port
function features again through the
switch was shipped from the factory, these features will be disabled (factory
default) when the configuration is reset. Only those ports that were enabled
at the factory will function. You will have to enable the additional port
function features again through the
dialog box.
Factory-default values may vary, depending on the firmware release installed
in your switch. For a list of values, refer to the MCDATA Sphereon 4500 Fabric
Switch Installation and Service Manual (620-000159).
in your switch. For a list of values, refer to the MCDATA Sphereon 4500 Fabric
Switch Installation and Service Manual (620-000159).