Microsoft ES4649 Manual Do Utilizador
Configuring the Switch
3-96
3
Command Attributes
• Member List (Current) – Shows configured trunks (Unit, Port).
• New – Includes entry fields for creating new trunks.
• Member List (Current) – Shows configured trunks (Unit, Port).
• New – Includes entry fields for creating new trunks.
- Unit – Stack unit. (Range: 1-8)
- Port – Port identifier. (Range: 1-25/49)
- Port – Port identifier. (Range: 1-25/49)
Web – Click Port, LACP, Configuration. Select any of the switch ports from the
scroll-down port list and click Add. After you have completed adding ports to the
member list, click Apply.
scroll-down port list and click Add. After you have completed adding ports to the
member list, click Apply.
Figure 3-56 LACP Trunk Configuration
CLI – The following example enables LACP for ports 1 to 6. Just connect these ports
to LACP-enabled trunk ports on another switch to form a trunk.
to LACP-enabled trunk ports on another switch to form a trunk.
Console(config)#interface ethernet 1/1
Console(config-if)#lacp
Console(config-if)#exit
.
.
.
Console(config)#interface ethernet 1/6
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Console(config)#interface ethernet 1/6
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type:
1000T
Mac address:
00-30-F1-D4-73-A2
Configuration:
Port admin:
Up
Speed-duplex:
Auto
Capabilities:
10half, 10full, 100half, 100full, 1000full
Flow control:
Disabled
Port security:
Disabled
Max MAC count:
0
Current status:
Created by:
LACP
Link status:
Up
Port operation status:
Up
Operation speed-duplex: 1000full
Flow control type:
Flow control type:
None
Member Ports: Eth1/1, Eth1/2, Eth1/3, Eth1/4, Eth1/5, Eth1/6,
Console#