Alcatel Carrier Internetworking Solutions omniswitch Manual Do Utilizador

Application Examples for File Management

Managing System Files

page 2-32

OmniSwitch 6600 Family Switch Management Guide

3 Enter the FTP mode by using the 

 command followed by the IP address or the name of the host you 

are connecting to. (If you enter a host name, please refer to 

->ftp 10.255.11.101

220 Connecting to [10.255.11.101]...connected.

Cosmo Windows FTP server ready

Name : Myhost1

Note. You can only use a host name instead of an IP address if the DNS resolver has been configured and 
enabled. If not, you must specify an IP address.

4 Enter a valid user name and password for the host you specified with the 

 command. A screen 

similar to the following displays:

Name (d) : Jsmith

331 Password required for Jsmith

Password: *****

230 User Jsmith logged in.

5 Use the FTP “put” command to transfer the file from your switch to the host as shown here.

ftp> put rrtest.txt

The following will display.

200 Port set okay

150 Opening BINARY mode data connection

Transferred 20 octets in 1 seconds.

226 Transfer complete

ftp>

6 To exit the switch’s FTP client mode, use the “quit” FTP command. Your current directory on the 
switch is /flash/working, which is the location from which you initiated the FTP client session. Use the 

 CLI command to verify your current directory.

ftp> quit

221 Bye

-> pwd

/flash/working

The following example describes the steps necessary to create a directory on a remote OmniSwitch and to 
transfer a file into the new directory using Secure Shell FTP. 

1 Log on to the switch and issue the 

 CLI command with the IP address for the device you are 

connecting to. The following command establishes a Secure Shell FTP interface from the local 
OmniSwitch to another OmniSwitch at IP address 10.222.30.125.

-> sftp 10.222.30.125

login as: