Kenwood KIV-700 Manual Do Utilizador

14   |   Quick Start Guide

Bend the tabs of the mounting sleeve 
with a screwdriver or similar utensil 
and attach it in place.

⁄

•  Make sure that the unit is installed 

securely in place. If the unit is unstable, it 
may malfunction (for example, the sound 
may skip).

1.  Engage the catch pins on the removal 

tool and remove the two locks on the 
upper level.
Lift up and pull the frame forward as 
shown in the figure.

Catch

Lock

Removal tool (Accessory

2

)

2.  When the upper level is removed, 

remove the lower two locations.

⁄

•  The frame can be removed from the 

bottom side in the same manner.

1.  Refer to the section <Removing the hard 

rubber frame> and then remove the 
hard rubber frame.

2.  Insert the two removal tools deeply into 

the slots on each side, as shown.

3.  Lower the removal tool toward the 

bottom, and pull out the unit halfway 
while pressing towards the inside.

Accessory 

2

¤

•  Be careful to avoid injury from the catch 

pins on the removal tool.

4.  Pull the unit all the way out with your 

hands, being careful not to drop it.

¤

Install this unit in the console of your 
vehicle. 
Do not touch the metal part of this unit 
during and shortly after the use of the 
unit. Metal part such as the heat sink and 
enclosure become hot. 

B59-2017-00_00_E.indb   14

B59-2017-00_00_E.indb   14

10/03/24   9:31

10/03/24   9:31