Allied Telesis AT-FS708LE Manual Do Utilizador

AT-FS708LE Installation Guide

29

6. Power ON the end-nodes connected to the 

switch.

7. Check that the LNK/ACT LED for each port 

on the switch is green. If a LED is OFF, refer 
to “Troubleshooting” on page 31.

The AT-FS708LE switch is now ready for use.

For wall-mount installation, you can position 
the switch vertically or horizontally on the wall 
using the keyhole cutouts in the bottom of the 
switch chassis.

For wall-mount installation, you must 
supply the two screws and plastic 
anchors or other material necessary to 
physically mount the switch to the wall. 

1. If attached, remove the rubber feet, data 

cables, and power cord from the switch.

2. Select a wall location for the switch.

3. Install two plastic anchors and two pan-head 

screws into the wall, separated by 5 
centimeters (approximately 2 inches).