Rhino Mounts SE4 Manual Do Utilizador
ASSEMBLY
SE4 05/05
Assembly Section 3-3
© 2005 Alamo Group Inc.
ASSEMBL
Y
A-FRAME INSTALLATION (FIGURE AsmP-R-0017)
1.
Attach “A” Frames (1) to inside of
welded hitch brackets on Mainframe,
insert Hitch Pin (12), Bushing (15), flat-
washer (11), lockwasher (14) and
install nut (13). Then attach to lug hitch
with bolt (22) and locknut (23).
insert Hitch Pin (12), Bushing (15), flat-
washer (11), lockwasher (14) and
install nut (13). Then attach to lug hitch
with bolt (22) and locknut (23).
2.
Install the lift straps (3) on inside of
top rails on mainshield (behind gearbox
mount) and attach with 1/2" x 1-1/2"
bolts (10) and locknuts (9).
mount) and attach with 1/2" x 1-1/2"
bolts (10) and locknuts (9).
3.
Insert spacer (7) between A-
frames (1). Insert 3/4" x 6" bolts (8)
thru hole in lift straps and spacer (7).
Secure with 3/4" locknut (9).
thru hole in lift straps and spacer (7).
Secure with 3/4" locknut (9).
TAIL WHEEL INSTALLATION (FIGURE 5)
4.
Align tailwheel beam weldment (16) between pivot brackets located behind gearbox
mount on mainshield weldment. NOTE: Long side of caster fork pivot tube is positioned
up. Attach tailwheel beam weldment to mainshield with 5/8" x 3-1/2" bolt (5) and locknut
(6).
up. Attach tailwheel beam weldment to mainshield with 5/8" x 3-1/2" bolt (5) and locknut
(6).
5.
Insert caster fork assembly (19) into tailwheel beam weldment (16). Install washer
(17) and secure with cotter pin (18).
6.
Place tailwheel adjusting brackets on to deck and secure with bolt (20) and locknut
(21).
7.
Position tailwheel beam weldment between tailwheel adjusting brackets on mainshield
weldment and secure with two 1/2" x 3" bolts (8) and locknut (9).
8.
Tighten all bolts to the proper torque.