Acer G300 Series Manual Do Utilizador
143
Installing the system into the rack
To install the system into the rack:
1
Remove the front panel from the server. Refer to “Removing the
front panel” on page 33 for instructions.
front panel” on page 33 for instructions.
2
Remove the foot stands from the server.
(1) Lay the server on its side on a flat, stable surface.
(2) Remove both of the screws from the center of each of the
server’s four foot stands. Keep the stands and screws for
later use.
later use.
3
Slide the stands inward, and remove them one by one.
The Altos G300 Rack mount kit contains two sets of rack brackets and
mounting rails. The rack brackets attach to the mounting rails to the
server tray. Each bracket is composed of three pieces: a detachable
inner rail and a fixed middle and outer rails. The mounting rails allow
the system to slide in and out of the rack mount for maintenance
purposes.
mounting rails. The rack brackets attach to the mounting rails to the
server tray. Each bracket is composed of three pieces: a detachable
inner rail and a fixed middle and outer rails. The mounting rails allow
the system to slide in and out of the rack mount for maintenance
purposes.
4
Remove the inner rail from the rack brackets.
(1) Extend the inner rail until the rail release latch clicks.
(2) Hold down the latch then slip the inner rail out.
aa300.book Page 143 Tuesday, December 17, 2002 5:27 PM