Lantronix EDS16PS Manual Do Utilizador

5. Click Submit.
6. Repeat above steps as desired, according to additional tunnel(s) available on your product.



Select Disable to disable Packing Mode completely. 



Select Timeout to send data after the specified time has 

elapsed. 



Select Send Character to send the queued data when the send 

character is received.

Threshold
(Appears for both Timeout 

and Send Character 

Modes)

Send the queued data when the number of queued bytes reaches 

the threshold.  When the buffer fills to this specified amount of data 

in bytes (and the timeout has not elapsed), the device packs the 

data and sends it out; applies only if the Packing Mode is not 

Disabled.

Timeout
(Appears for Timeout 

Mode)

Enter a time, in milliseconds, for the device to send the queued 

data after the first character was received.  Specifies the time 

duration in milliseconds; applies only if the Packing Mode is 

Timeout.

Send Character
(Appears for Send 

Character Mode)

Enter the send character (single printable or control). Upon 

receiving this character, the device sends out the queued data.  

The data is packed until the specified send character is 

encountered. Similar to a start or stop character, the device packs 

the data until it sees the send character. The device then sends the 

packed data and the send character in the packet.  Applies only if 

the Packing Mode is Send Character.

Trailing Character
(Appears for Send 

Character Mode)

Enter the trailing character (single printable or control). This 

character is sent immediately following the send character.  This is 

an optional setting. If a trailing character is defined, this character is 

appended to data put on the network immediately following the 

send character.