DELL 3000i Manual Do Utilizador

38

Setting Up Your iSCSI Storage Array

Set the management port IP 
addresses on each controller. 

To set the management port IP 
addresses to match your public 
network configuration. Although 
DHCP is supported, static IP 
addressing is recommended. 

In MD Storage Manager, select 
Initial Setup Tasks

→ 

Configure 

Ethernet Management Ports, then 
specify the IP configuration for each 
management port on the storage 
array controllers.

NOTE: 

If you change a management 

port IP address, you may need to 
update your management station 
configuration and/or repeat storage 
array discovery.

Set up alert notifications.

Set up e-mail alerts.
Set up SNMP alerts.

NOTE: 

The Status area in the 

Summary tab shows if alerts have 
been set for the selected array.

To arrange to notify individuals (by 
e-mail) and/or storage management 
stations (by SNMP) when a storage 
array component degrades or fails, 
or an adverse environmental 
condition occurs.

E-mail — Sender (sender’s SMTP 
gateway and e-mail address) and 
recipients (fully qualified e-mail 
addresses)

SNMP — (1) A community name, a 
known set of storage management 
stations set by administrator as an 
ASCII string in the management 
console (default: "public"), and (2) 
a trap destination, IP address or host 
name of a management console 
running an SNMP service

Table 4-5.

Initial Storage Array Setup Tasks (continued)

Task

 

Purpose

Information Needed