Intel 5800/120Ld Manual Do Utilizador
Upgrading Your System 4-11
10. Position the processor back into the URM. Ensure that the
alignment notch on the bottom of the SECC2 cartridge fits into
the connector key in Slot 1. Push down firmly, with even
pressure on both sides of the top, until clicking noises are heard
as the cartridge is seated.
the connector key in Slot 1. Push down firmly, with even
pressure on both sides of the top, until clicking noises are heard
as the cartridge is seated.
11. Replace the left side panel, plug in the system power cord, and
power up the system.
DIMMs
The system board contains four DIMM sockets labeled 1 through 4 (Figure 4-8).
Each socket can hold a single 72-bit DIMM module with 64MB, 128MB,
256MB, 512MB, or 1GB of memory. When all four sockets are populated, the
system board supports a maximum of 4 GB of memory with 1GB DIMMs. A
DIMM will always be installed in socket 1. When you install additional
DIMMs, you must start with the first empty socket next to the DIMMs already
installed. When you remove DIMMs, you must start with the highest number
occupied DIMM socket on the system board.
Each socket can hold a single 72-bit DIMM module with 64MB, 128MB,
256MB, 512MB, or 1GB of memory. When all four sockets are populated, the
system board supports a maximum of 4 GB of memory with 1GB DIMMs. A
DIMM will always be installed in socket 1. When you install additional
DIMMs, you must start with the first empty socket next to the DIMMs already
installed. When you remove DIMMs, you must start with the highest number
occupied DIMM socket on the system board.
Figure 4-8. DIMM Locations