IBM 8682 Manual Do Utilizador
v
The server supports three standard and three optional 1-inch (26 mm) slim-high,
3.5-inch, hot-swap hard disk drives in the hot-swap bays. The standard hot-swap
bays are bays 1 through 3 (from bottom to top). The optional hot-swap bays are
bays 4 through 6 (from bottom to top). Bays 1 through 3 are located in the
standard hard disk drive cage, to the left of bays 4 through 6 in the optional hard
disk drive cage.
3.5-inch, hot-swap hard disk drives in the hot-swap bays. The standard hot-swap
bays are bays 1 through 3 (from bottom to top). The optional hot-swap bays are
bays 4 through 6 (from bottom to top). Bays 1 through 3 are located in the
standard hard disk drive cage, to the left of bays 4 through 6 in the optional hard
disk drive cage.
Note: The server does not support half-high hot-swap drives or internal tape
drives.
v
The hot-swap bays connect to a hot-swap drive backplane. The backplane is a
printed circuit board behind the bays.
printed circuit board behind the bays.
Hard disk drive component locations
The following illustration shows the hot-swap-drive backplane component locations,
as viewed from the front of the server.
as viewed from the front of the server.
Note: The illustrations in this document might differ slightly from your hardware.
Hard disk
drive activity
light (green)
drive activity
light (green)
Hard disk
drive status
light (amber)
drive status
light (amber)
SCSI hot-swap
hard disk drive
connector
hard disk drive
connector
Note: The hard-disk drive activity light and hard-disk drive status light on the
backplane match the hard-disk drive activity light and hard-disk drive status
light on the front of the server (see “Start the server” on page 8).
light on the front of the server (see “Start the server” on page 8).
60
IBM xSeries 350 Type 8682: Hardware Maintenance Manual