Fujitsu BX400 S1 Manual Do Utilizador

BX400 S1

Operating Manual

51

The cables are routed along the support uprights of the rack.

The system unit has four bays for hot-swap power supply units. In the base 
configuration, it is fitted with one power supply unit.

V

●

Read the information on determining how many power supply units 
are required (see 

).

●

The power supply units automatically adjust to a mains voltage 
between 100 - 240 V. The system unit may only be used if the local 
mains voltage is within the voltage range of the system.

●

The 1600 W power supply units may only be connected to 16 A 
power outlets, a UPS, a 32 A power distribution unit, or CEE sockets. 
When ordering the system unit, you must specify which socket type 
is available at the installation location, so that the cables with the 
appropriate C19 connectors can be supplied.

– For the Japanese market:

The 1600W power supply units may only be connected to NEMA 
L6-15, IEC 60320-C20, or NEMA 5-15 sockets.

●

Always connect the cable first to the power supply unit and then to the 
mains.

Ê

First connect the insulated C19 connector of the power cable to the power 
supply units of the system unit, and then plug the connector into the UPS, 
power distribution unit or an external socket. The system can be configured 
to support *True AC redundancy or non-AC redundancy.

I

True AC redundancy is recommended for systems used for critical 
business applications. This will result in the system to continue operation 
during a power failure as the redundant part of the subsystem is plugged 
into a separate AC source [e.g. uninterruptable power supply (UPS)).

I

Refer to tables below for maximum DC loading for both AC redundant 
and AC non redundant configurations.