Lucent Technologies 555-233-115 Manual Do Utilizador
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Adding or Removing Cabinet Hardware
6-61
Add IP Interface Assembly
6
Connect the Ethernet
1. Connect the network cable to the ETHERNET connector on the TN802B
external cable assembly.
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
Install the Circuit Pack
!
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against
electrostatic discharge (ESD) by wearing a grounded wrist strap.
electrostatic discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN802B IP Interface is hot-swappable, so you do not need to power
down the carrier to install it.
down the carrier to install it.
If you need to remove the TN802B IP Interface from the carrier at a later
time, shut down Windows NT first by pressing the recessed reset button on
the faceplate (see
time, shut down Windows NT first by pressing the recessed reset button on
the faceplate (see
) of the TN802B IP Interface until the LCD
shows a flashing MSHUT *. When the flashing stops and the asterisk
disappears (about 2 min), it is safe to remove the circuit pack.
disappears (about 2 min), it is safe to remove the circuit pack.