Netgear RNDP6310-100NAS Manual Do Utilizador

b.  Pull out the disk tray, place the new disk on the tray, and assemble the disk and tray 

with the screws that came with your unit. 

c.  Make sure that the hard disk connectors face the interior of the disk bay. 

d.  Slide the disk tray back into the unit and press the handle to secure the disk.

Turn the unit on and perform a factory reboot.

e.  See 

Note: This process erases all data and formats the disk as 

X-RAID2

TM

. If you are using a previously formatted disk that contains 

data you want to preserve, you must move the data to an external 
drive before using the previously formatted disk in your ReadyNAS 
unit.

The factory reboot process can take up to 30 minutes while your unit tests and formats 
the disk, installs the operating system, and creates a volume. This process can take up to 
30 minutes; you can follow the progress in RAIDar. For more information about RAIDar, 
see the software manual for your unit, which is available at 

. 

If you are installing multiple disks at the same time, they must synchronize. This might 
take several hours, depending on the disk size. You can continue to use your ReadyNAS, 
although access is slower until the volume synchronization finishes.