NCR S26 Manual Do Utilizador
Installing and Removing SIMMs
3-8
Adding and Replacing Components
Installing SIMMs
To install a SIMM, follow these steps:
1. Carefully slip a SIMM at a 45
o
angle into a socket. Make sure that the
curved edge that indicates pin 1 of the SIMM matches pin 1 of the socket.
Figure 3-2. Installing a SIMM
1
2
Peg
Hole
Pin 1 Indicator
(curved edge)
CAUTION: A SIMM fits only in one direction. If you slip in a SIMM but it
does not appear to completely fit, you may have inserted it the wrong way.
does not appear to completely fit, you may have inserted it the wrong way.
2. Gently push the SIMM to a vertical position until the pegs of the socket
slip into the holes on the SIMM. Make sure the holding clips lock the
SIMM into position.
SIMM into position.
Note: The SIMM should be at a 90
o
angle when installed on the system
board.