NCR S26 Manual Do Utilizador

Power Saving Configuration

4-22

Using the BIOS Setup Utility

This parameter permits the hard disk to enter standby mode after inactivity of
1 to 15 minutes, depending on your setting. When you access the hard disk
again, allow 3 to 5 seconds (depending on the hard disk used) for the disk to
return to normal speed. Set this parameter to Off if your hard disk does not
support this function.

This parameter supports the lowest power saving mode. To resume system
operation from suspend mode, you can either press a key or move the mouse.
Any IRQ activity representing green/wake up events also resumes system
operation. See the following heading, “System Wake Up Events.”

Note:  If you connected the system to a network, we strongly suggest you set
this item to OFF.

This parameter permits you to monitor system activities occurring through the
IRQ and determine whether or not to enter power saving mode.

For example, if you assign IRQ3 to a fax/modem, and you set this item to
Enabled, any fax/modem activity wakes up the system from suspend mode.