Patton electronic 2960 Manual Do Utilizador
Completing the installation
48
Model 2960/2996 RAS User Manual
3 • Configuring the RAS for operation
Note
If the RAS does not respond as described, the most likely cause is that
the RAS default settings are not compatible with the T1/E1 line. If
this is the case, use the RS-232 CONFIG port to correct the RAS set-
tings. You will have to examine the T1/E1 Link section in the config-
uration pages in the RAS.
the RAS default settings are not compatible with the T1/E1 line. If
this is the case, use the RS-232 CONFIG port to correct the RAS set-
tings. You will have to examine the T1/E1 Link section in the config-
uration pages in the RAS.
6. There are two LEDs on the RAS 10/100 Ethernet port: a green LED that indicates line speed, and a yellow
LED that indicates link status and activity.
Verify that the yellow LED is either flashing yellow (meaning that packets are being received at the Ether-
net port) or solid yellow (meaning that the link is valid but no packets are being received).
net port) or solid yellow (meaning that the link is valid but no packets are being received).
Congratulations! Your RAS is now installed. For more in-depth information about configuring your RAS set-
tings, refer to the Access Server Administrator’s Reference Guide available online at www.patton.com/manuals/
29xx-arg/pdf. Otherwise, refer to Chapter 4, “Operation and shutdown” for information on activating and
de-activating your remote access server.
tings, refer to the Access Server Administrator’s Reference Guide available online at www.patton.com/manuals/
29xx-arg/pdf. Otherwise, refer to Chapter 4, “Operation and shutdown” for information on activating and
de-activating your remote access server.