Citrix Systems 9.3 Manual Do Utilizador

If you are configuring your appliance as an Access Gateway, see "

Note: For information about deploying a high availability (HA) pair, see
"

."

To configure the appliance by using the Setup Wizard in the configuration utility, you
need an administrative computer configured on the same network as the appliance. To
run the configuration utility, the Java RunTime Environment (JRE) version 1.4.2_04 or
later must be installed on the workstation or laptop. You can use the Setup Wizard to
configure the following initial settings on the appliance:

w

System IP address and subnet mask

w

Subnet or Mapped IP address and subnet mask

w

Host name

w

Default gateway

w

Time zone

w

Licenses

w

Administrator password

Important: Before running the Setup Wizard, you should download your licenses from
the Citrix Web site and put them in a location on your computer or another device
where you can access them from your Web browser during configuration.

Note: If the appliance is configured with the default IP address, licenses are not
installed on the appliance, or the mapped or subnet IP address is not configured, the
configuration utility automatically opens the Setup Wizard when you log on to the
appliance.

1. In a Web browser, type: http://192.168.100.1

Note: The NetScaler software is preconfigured with a default IP address and
associated netmask. The default IP address is 192.168.100.1 and the default
netmask is 255.255.0.0.

Citrix NetScaler Hardware Installation and Setup Guide

93