Honeywell 1450g Manual Do Utilizador
4 - 11
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the
the scanner continues scanning until either the
(page 4-12), the deactivation character is
received (see
on page 4-12), or a bar code is transmitted. Scan the following On bar code to use char-
acter activation, then use Activation Character (following) to select the character you will send from the host to start scanning.
Default = Off.
Activation Character
This sets the character used to trigger scanning when using Character Activation Mode. On the
, page A-3, find the hex value that represents the character you want to use to trigger scanning. Scan
the following bar code, then use the
to read the alphanumeric combination that represents that ASCII
character. Scan
to finish.
Short (1000ms)
Medium (2000ms)
Long (3000ms)
Extra Long (4000ms)
* Off
On
Activation Character