Honeywell 3800gPDF Manual Do Utilizador

3 - 3

This sets the minimum amount of time before the imager can read another bar 
code.  

Default = No Delay.

If you want to set your own length for the good read delay, scan the bar code 
below, then set the delay (from 0-30,000 milliseconds) by scanning digits from 
the inside back cover, then scanning 

Save. 

You can activate the imager either by pressing the trigger, or using a serial trig-
ger command (see 

on page 11-4).  When in manual trigger 

mode, the imager scans until a bar code is read, or until the trigger is released.  

When in serial mode, the imager scans until a bar code has been read or until 
the deactivate command is sent.  In serial mode, the imager can also be set to 
turn itself off after a specified time has elapsed (see 

, which fol-

lows). 

Use this selection to set a time-out (in milliseconds) of the imager’s trigger when 
using serial commands to trigger the imager.  Once the imager has timed out, 
you can activate the imager either by pressing the trigger or using a serial trig-

* No Delay

Short Delay (500 ms)

Medium Delay (1000 ms)

Long Delay (1500 ms)

User-Specified Good Read Delay

* Manual/Serial Trigger