Xerox 3460 Manual Do Utilizador
Xerox DocuMate 3460
User’s Guide
161
Error Light Troubleshooting Codes
The status light indicates the current state of the scanner. Descriptions of the most common patterns
are listed below. Contact Xerox Technical Support if you experience a different blinking pattern.
are listed below. Contact Xerox Technical Support if you experience a different blinking pattern.
Normal Operation
•
Steady blue: indicates the scanner is ready to scan.
•
Steady red: the scanner is busy or it is not connected to the computer.
•
Blinking red: the scanner is reporting an error.
Error Codes
If your scanner experiences hardware problems, the status light turns red and will blink a specific
number of times, the status light will blink red, and the LED flashes an “E” then the error code number.
number of times, the status light will blink red, and the LED flashes an “E” then the error code number.
In all cases, you should turn off the scanner and check the scanner setup. Make sure the USB cable is
plugged into the scanner and computer. Make sure the power cord is plugged into the scanner and into
a wall outlet or USB port.
plugged into the scanner and computer. Make sure the power cord is plugged into the scanner and into
a wall outlet or USB port.
Error
Code
Code
Problem Description
Solution
0
Scanner is not connected to the
computer. (The LED does not
flash “E” and the status light
remains blue.)
computer. (The LED does not
flash “E” and the status light
remains blue.)
A cable may be loose. Check that the scanner’s cables are cor-
rectly attached to the computer. If the scanner still does not con-
nect, re-boot the computer.
rectly attached to the computer. If the scanner still does not con-
nect, re-boot the computer.
4 or 5
The scanner lamp is either turned
off or the lamp has not warmed
up enough to initiate scanning.
off or the lamp has not warmed
up enough to initiate scanning.
In the One Touch hardware properties turn the scanner lamp on. If
the lamp is already on, turn the lamp off then on again. If the
problem persists and your scanner’s power is plugged into a surge
protector or UPS battery backup, try plugging the scanner power
directly into a wall outlet.
the lamp is already on, turn the lamp off then on again. If the
problem persists and your scanner’s power is plugged into a surge
protector or UPS battery backup, try plugging the scanner power
directly into a wall outlet.
6
The scanner’s cover is open.
The ADF door is not closed all the way. Open the scanner then
close it again. Push down on the lid until it locks into place.
close it again. Push down on the lid until it locks into place.
7 or 8
The lamp in the scanner body or
lid has malfunctioned.
lid has malfunctioned.
This usually occurs if the power was disconnected during a scan.
Turn the scanner off, then back on again. If the problem persists,
turn off the scanner, re-start the computer, then turn the scanner
on.
Turn the scanner off, then back on again. If the problem persists,
turn off the scanner, re-start the computer, then turn the scanner
on.
9
Paper jam
Open the ADF cover and remove the jammed page. See
All
Other
Codes
Other
Codes
An internal part in the scanner
may have malfunctioned.
may have malfunctioned.
Turn off the power to your scanner, then turn it back on. If the
problem persists, re-boot your computer. If the problem still per-
sists, contact Xerox Technical Support.
problem persists, re-boot your computer. If the problem still per-
sists, contact Xerox Technical Support.