Canon DR-M160 Manual Do Utilizador
15
S
e
tup Guide
STEP 4
Turning the Power ON
The power of the scanner can be turned ON and OFF with the power
button on the front of the scanner.
button on the front of the scanner.
1
Make sure that the scanner and computer are connected
properly.
properly.
2
Press the power button.
The power button lights blue when the power turns ON.
Hint
A balloon message such as shown below appears on the task bar. If
you wait a while, automatic scanner recognition will end and the
scanner will become ready to use.
you wait a while, automatic scanner recognition will end and the
scanner will become ready to use.
Ð
When the scanner is properly connected to the computer, the
(CaptureOnTouch) icon appears on the taskbar as follows.
If the taskbar icon appears as
, the scanner is not properly
connected to the computer. Check the status of the power switch and
USB cable.
USB cable.
Turning Off the Power
Press and hold the power button until the indicator goes out.
IMPORTANT
• After turning the scanner off, wait at least 10 seconds before turning
it back on.
• If you will not be using the scanner for an extended period, you
should disconnect the power cord from the AC outlet for safety.
Power button
This completes setup.
0-00-DR-M160_RG_UK.book Page 15 Thursday, June 9, 2011 8:04 PM