Canon Model 6401 B Manual Do Utilizador
Field Test Unit Software
7.7.2 “T” - TIME
This command enables the user to check and/or reset the logger’s time and
date. The Canon X-07’s date and time MUST be set accurately for this pro-
cedure. If the Canon’s time/date needs to be changed type “t” to reset it, (see
cedure. If the Canon’s time/date needs to be changed type “t” to reset it, (see
below under X-07 Commands).
EXAMPLE:
Press “T”
FTU display responds:
FTU display responds:
10:58:28
10:45:21
87/05/29
87/05/28
logger
canon
Press Return or Put
If the date on the logger side is as desired then press RETURN to exit. If
not the press Put - “P” to set the logger’s date to that of the Canon.
not the press Put - “P” to set the logger’s date to that of the Canon.
7.7.3 “d” - DISPLAY *
This command causes the FTU to display current information from the log-
ger on:
• Cycle time of the logger
• Log size (number of bytes used per log)
• Log interval in minutes and seconds
• Time of the first log, the number of logs made and the
number of full days the logger has been recording
EXAMPLE:
Press shift-D (“d”)
FTU display responds:
1 second logger
1 byte log size
1 min 0 second
1 byte log size
1 min 0 second
log interval
First log at
12:09:00 87/05/29
3 logs 0 days
press RETURN
press RETURN
3 6
Section 7. FTUC COMMANDS