Multiquip b46s90 Manual Do Utilizador

6.  Using a wrench, tighten the brass set #2 nut up against 

the yoke boss. This will lock the cable in place.

7.  Use a wrench and finish tightening the brass set #1 

nut up against the yoke boss.

1.  After the Quick-Pitch™ handle has been installed on 

the trowel, spring pre-load adjustment will be required.

2.  Locate the spring pre-load adjustment screw (Figure 13) 

on the underside of the handle tube.

3.  A decal has been placed on the side of the handle 

tube to assist the user in the adjustment of the spring.

BLADE

PITCH

CABLE

YOKE

YOKE

EYELET

BRASS SET

NUT #1

BRASS SET

NUT #2

The Quick Pitch™ handle is spring loaded, personal 

injury or damage could result from improper handling, 

installation or adjustment. Use extreme caution when 

installing this component.

ADJUSTMENT

SCREW

SLIDER

GROOVE

ALIGNMENT

DECAL

PRELOAD TRIM INDICATOR

PRELOA

D

TRIM INDICA

TO

R

4.  Align the groove on the slider with the text "B" FINISH 

or "B" COMBO on the decal. The letter "B" stands for 

B-46 Walk-Behind Trowel

1.  Read all safety instructions at the beginning of manual.
2.  Clean the trowel, removing dirt and dust, particularly 

the engine cooling air inlet, carburetor and air cleaner.

3.  Check the air filter for dirt and dust.  If air filter is dirty, 

replace air filter with a new one as required.

4.  Check carburetor for external dirt and dust. Clean with 

dry compressed air.

5.  Check fastening nuts and bolts for tightness.

1.  To check the engine oil level, place the trowel on secure 

level ground with the engine stopped.

2.  Remove the dipstick from the engine oil filler hole 

(Figure 14) and wipe clean.

alwayS wear approved eye and hearing 

protection before operating the trowel.

NeveR place hands or feet inside the guard 

rings while the engine is running. 

shut the engine down before performing any 

kind of maintenance service on the trowel.